Support Center
Looking for answers? You've come to the right place.
Technical Support FAQs
New User FAQs
- Beginner Set Up and Operation of the Ghost Gunner 3
- Three Tips for Success
- Installing DDCut on Windows
- DDCut MAC Installation
- Routine Maintenance and Cleaning
- Running Codes on DDCut V
General Milling Operation FAQs
- Proper Tool and Collet Installation
- Securing the Workpiece
- Tooling
- Probe Circuit Troubleshoot
- Resume Milling Operation After Partial Run
- Anodized and Non Conductive Work-piece
Software and Firmware
AR-15 and AR-308 Milling Operation FAQs
- AR Zero Milling Guide
- AR-15 and AR-308 80% Milling Guide
- Verify End Mill Placement in AR Lowers
- Milling Partially Completed Lowers
- Diagnosing Offset Fire Control Group (FCG) Pocket In AR Lowers
- Diagnosing Selector and Pin Hole Offsets